Sika AnchorFix®-1 300 ml

Product Description

Sika AnchorFix®-1300 is a solvent- and styrene-free, polyester-based, two-component, fast-curing anchoring material. Thanks to its high adhesion strength and load-carrying capacity, it provides safe fixation in concrete and various building materials. It can be easily applied with standard cartridge guns and maintains its performance even at low temperatures. It does not sag in overhead applications and offers comfortable use with its low-odor structure. Areas of Use It is used as a fast-curing anchor material in the following applications: Rebar (sprout planting) applications Metric rod and rod fixings Bolts and special fixing systems concrete surfaces Hollow and solid brick Hard natural stone* hard rock* * Note: On natural stone and similar surfaces, it is recommended to test before application to ensure the desired adhesion strength and to prevent stains or color changes on the surface. Porosity and strength properties of the surfaces may vary. Advantages Fast curing Applicable with standard guns Can be used at low temperatures High load carrying capacity ETA approved Does not sag in overhead applications Does not contain styrene It has little odor Provides low material loss Color Information Standard Color: Component A: White Component B: Black Mix color: Light gray Stone Color: Component A: White Component B: Salmon Mix color: Beige Approvals and Standards For hollow blocks: ETAG 029, ETA-12/0227, CE marked For concrete applications: ETAG 001 (Annexes 1 and 5), ETA-13/0720, CE marked Technical Information Mixing Ratio: A : B = 10 : 1 (by volume) Maximum Layer Thickness: 3mm Sagging: Does not sag even in overhead applications Product Temperature: +5 °C / +40 °C Outdoor & Surface Temperature: –10 °C / +40 °C Surface temperature must be at least 3 °C above dew point Curing Time TemperatureOpen Holding (Tgel)Curing (Tcur)+30 °C4 min35 min+25 – +30 °C4 min40 min+20 – +25 °C5 min50 min+10 – +20 °C6 min85 min+5 – +10 °C10 min145 min+5 °C18 min145 min–10 °C30 min24 hours Notes: Minimum cartridge temperature: +5 °C –10 °C applications are outside the scope of ETA.